24
MIDI SETUP
MIDI settings are made in the MIDI menu, which apply to all scenes. Note that some MIDI
parameters can be set differently for the patterns' tracks.
Press the MIDI button to enter the menu. Step through the parameters by pressing the
MIDI button several times. The display shows the menu name and the associated value
by flashing (except MIDI dump). Change the value with the DATA controller. If necessa-
ry, select the track using the track buttons.
When the value is changed, the MIDI settings are automatically saved permanently. The
MIDI menu also contains the function for loading and saving a scene via SYSEX dump.
The following parameters can be set separately for the tracks:
"rCh" - MIDI receive channel of the track Value range "1-16"
"tCh" - MIDI send channel of the track Value range "1-16"
"not" - Note: MIDI note number of the track Value range "0-127"
The following additional global parameters can be set:
"rPr" - ProgChange receive MIDI channel Value range "oFF, 1-16"
"SPr" - ProgChange transmit MIDI channel Value range "oFF, 1-16"
"rCL" - MIDI-CLOCK receiving Value range "On/oFF"
"SCL" - SEND-CLOCK (Midiclock send) Value range "On/oFF"
SYSEX dump of a SCENE
The currently loaded Scene can be saved to a computer. To do this, go to the MIDI menu
and step to the last parameter “SSC” / “rSC”. Switch between both functions by turning
the DATA knob.
"SSC" - Dump Scene: Send Scene via SYSEX via MIDI-OUT
Here the scene can be sent via MIDI-OUT as a SYSEX file. Start sending by pressing the
DATA control. The progress of sending will flash on the display. Sending takes approx. 40
seconds.
"rSC" - Dump Scene: Receive Scene via SYSEX via MIDI-IN
Here a Scene SYSEX file can be loaded via MIDI-IN. Start sending the SYSEX file on
your computer. Reception will flash in the display. After receipt, the scene is in memory
and must be saved to a scene storage location in order to remain permanently in the
module.
Also note that receiving the Scene will overwrite the currently loaded Scene.
To Next Page
Loading...
