Please keep this User Manual for future
user, be sure that they also receive this
instruction booklet.
Unpack and check carefully there is no
transportation damage before using the
Before operating, ensure that the voltage
and frequency of power supply match the
It’s important to ground the yellow/green
conductor to earth in order to avoid electric
shock.
Disconnect main power before servicing
and maintenance.
only, but always by taking its base.
Do not use the device in high humidity
conditions. Use in -10°C to +35°C
In the event of serious operating problem,
carried out by unskilled people can lead to
damage or malfunction. Please contact the
nearest authorized technical assistance
center. Always use the same type spare parts.
Do not connect the device to any dimmer
pack.
Do not touch any wire during operation
and there might be a hazard of electric shock.
To prevent or reduce the risk of electrical
or moisture.
visibly damaged.
WARNING!
to the power supply in order to avoid
condensation. Working temperature from
-30°C to + 50°C.
2. SAFETY INFORMATION
1. INTRODUCTION
Moving Heads 8R BEAM
User Manual •Instrukcja Obsługi
WARNING! The Moving Heads 8R BEAM has a powerful pan motor. The torque reaction
unsecured on a surface. Do not apply power to the Moving Heads 8R BEAM unless the baase
is securely fastened to a surface or to rigging hardware.
WARNING!
90 clockwise.
WARNING!
with the yoke hanging vertically downwards, use two clamps of half-coupler type. Do not
use any type of clamp that does not completely encircle the structure when fastened.
WARNING!
or any other strong light source from any angle - even for a few seconds. See Figure 2. The
Moving Heads 8R BEAM lens can focused the sun's rays, creating a potential fire hazard and
causing damage.
IMPORTANT!Moving Heads 8R
BEAM, as intense illumination can damaged the display.
WARNING!
Figure 2.
To Next Page
Loading...
Need help?
General
