WARNING! The Moving Head 60W Spot has a powerful pan motor. The torque reaction when the
head is panned suddenly can cause the base to move if the fixture is standing unsecured on a
surface. Do not apply power to the Moving Head 60W Spot unless the baase is securely fastened
to a surface or to rigging hardware.
WARNING! Use 2 clamps to rig the fixture. Do not hang the fixture from only one clamp. Lock
each clamp with both 1/4-turn fasteners. Fasteners are locked only when turned a full 90
clockwise.
WARNING! When clamping the fixture to a truss or other structure at any other angle than with
the yoke hanging vertically downwards, use two clamps of half-coupler type. Do not use any type
of clamp that does not completely encircle the structure when fastened.
WARNING! Position or shade the head so that the front lens will not be exposed to sunlight or
any other strong light source from any angle - even for a few seconds. See Figure 2. The Moving
Head 60W Spot lens can focused the sun's rays, creating a potential fire hazard and causing
damage.
IMPORTANT! Do not point strong light output from other fixtures at the Moving Head 60W Spot,
as intense illumination can damaged the display.
WARNING!
User Manual •Instrukcja Obsługi
Figure 2.
Shield or shade the head if necessary.
• Please keep this User Manual for future
user, be sure that they also receive this
instruction booklet.
• Unpack and check carefully there is no
transportation damage before using the
• Before operating, ensure that the voltage
and frequency of power supply match the
• It’s important to ground the yellow/green
conductor to earth in order to avoid electric
shock.
• Disconnect main power before servicing
and maintenance.
•
but always by taking its base.
• Maximum ambient temperature is: 40
Don’t operate it where the temperature is
higher than this.
• In the event of serious operating problem,
carried out by unskilled people can lead to
damage or malfunction. Please contact the
nearest authorized technical assistance
center. Always use the same type spare parts.
• Do not connect the device to any dimmer
pack.
• Do not touch any wire during operation and
there might be a hazard of electric shock.
• To prevent or reduce the risk of electrical
or moisture.
• The housing must be replaced if they are
visibly damaged.
• Do not look directly at the LED light spot
2. SAFETY INFORMATION
1. INTRODUCTION
Moving Head 60W Spot
To Next Page
Loading...