Flash LED MOVING HEAD 60W User Manual

www.flash-butrym.pl
2
1 INTRODUCTION
Thank you for purchasing LED MOVING HEAD 60W. For safety reasons and to ensure the trouble-free
operation, carefully read the instructions.
2 SAFETY INFORMATION
1. Installation should be done by qualified personnel in order to minimize the risk of accidental
electric shock
2. Disconnect the power supply before installation.
3. Before connecting the unit to the mains, make sure it is not damaged mechanically. If you
notice any signs of damage you should contact your dealer immediately. Do not connect the
device to the mains.
4. Do not use the device in high humidity conditions and at temperatures above 40° C
5. To avoid damage please don't use organic solvents to clean the fixture shell.
6. The device must be installed on stable structures
7. Wait 20 minutes to fully cool the light before re-use.
3 PRODUCT INFORMATION
3.1 Specification
 Power consumption: 120W
 Power supply voltage: 110 - 220V
 Voltage frequency: 50/60Hz
 Diode type: Standard LED (Single color)
 Number of diodes: 1
 Display: LED - 4 characters
 Color: White
 Dimming: Linear: 0 - 100%
 Flash frequency (min): 1Hz
 Flash frequency (max): 10Hz
 Prism: 3-facet
 GOBO wheel: 6 patterns+ open, rotating
 PAN range: 630°
 TILT range: 270°
 DMX standard: DMX 512
 Control interface: 4 buttons
 AC IN: IEC - C14
 DMX IN: XLR - 3 pin
 DMX OUT: XLR - 3 pin
 Housing made: ABS
 Cooling: Passive
 Height [cm]: 35
 Width [cm]: 26
 Depth [cm]: 26
 Weight [kg]: 7
 Weight with packaging [kg]: 7,4

Flash LED MOVING HEAD 60W Specifications

General

Brand	Flash
Model	LED MOVING HEAD 60W
Category	DJ Equipment
Language	English