Flavel FDW65 - Operating the Product; Function Keys; Preparing the Machine; Programme Selection

30/
EN
OperatIng the product
6-
key
Select the programme by pressing the
desired programme key.
Press the Start / Pause / Cancel key for 3
seconds to cancel the running programme.
Function Keys
If you press any of the Function keys
during programme selection or time delay
selection, the indicator of the function will
flash if the programme you have selected
supports the selected function.
To cancel the selected function, press the
function key again.
Preparing the machine
1. Open the door of the dishwasher.
2. Place the dishes in accordance with
the instructions in the user manual.
3. Make sure that the upper and lower
impellers rotate freely.
4. Put adequate amount of detergent into
the detergent dispenser.
5. Check if the Salt and Rinse Aid
indicators light and add salt and/or
rinse aid if needed.
Programme selection
1. Press the On/Off button to turn on your
machine.
2. Refer to the table of "Programme data
and average consumption values"
to determine a washing programme
suitable for your dishes.
3. Selected programme will start when
you close the door of your machine.
Auxiliary functions
Washing programmes of your dishwasher
are designed to obtain the best cleaning
effect, considering the type of the soiling,
soiling degree and properties of the dishes
to be washed.
Auxiliary functions allow you save from
time, water and power.
Auxiliary functions may cause changes
in the programme duration.
Auxiliary functions are not suitable for
all washing programs. Indicator of the
auxiliary function that is not compatible
with the programme will not be active.
Fast+ Function
(Depends on model)
It shortens the time of the washing cycle
selected and decreases water consumption
by enabling washing under higher pressure.
SteamGloss Function
(Depends on model)
It provides superior drying performance.
Half Load function
(Depends on model)
It is used to operate the machine without
loading it completely.
1. Load your dishes in the machine as
you like.
2. Turn the machine on with On/Off key.
3. Select the desired programme and
press the Half Load key.
While the function is enabled, the Half Load
indicator will become on in the function
selection indicator and on the display.
4. Close the door of the machine to start
the programme.
With the Half Load function you can
save both water and power while using
the lower and upper baskets of the
machine.
Read “Safety Instructions” section first!
Read “Quick Quide” before this
section.