4
Unpacking The Appliance
This Flavel Electric heater is supplied in a single pack carton.
All Instructions should be read prior to installing the appliance.
Ensure all parts including loose items have been removed prior to discarding the packaging.
Product Checklist
1 off Flavel electric heater main body including bulb assembly units
1 off Ceramics pack (contains four ceramic plaques)
1 off Fixing kit
1 off Instruction / guarantee Literature
1 off Control knob
Appliance Fixing
BEFORE PROCEEDING, ENSURE THE APPLIANCE IS DISCONNECTED FROM
THE MAINS SUPPLY. IF IN DOUBT SEEK THE ASSISTANCE OF A QUALIFIED
ELECTRICIAN.
Wall Mounting. (Non Combustible Walls Only)
NOTE: When the fire is wall mounted, the base of the fire must be a
least 150mm above the floor level.
a) Remove the dress guard by springing the location wires out at the top (at the sides
on Renaissance models) and lifting away. Take care not to scratch the trim.
b) Remove the radiant's and their packaging from the fire and store in a safe place.
c) Remove the two lower outer case fixing screws and the two upper outer case fixing
screws. (On Strata models the case is only secured by lower outer case fixing
screws). Remove the outer case by lifting upwards and away, ensuring the rear of
the outer case clears the top of the switch spindle area at the top right.
Remove the legs from the base of the fire if wall mounting.
d) Mark the position of the upper fixing holes on the wall with reference to diagram
overpage. The height of the upper holes should be at least 580mm above the floor.
This will determine the 145mm height required from the base of the fire to the floor.
To Next Page
Loading...
