7
IMPORTANT - Safety Cut Out
This appliance is fitted with an automatic safety cut out. This operates if the air inlet or outlet of
the heater become blocked or covered. This will prevent the fan heater from operating.
In order to RESET the appliance the following procedure should be followed:-
Switch OFF the appliance and disconnect the appliance from the mains supply
Leave the appliance disconnected for a MINIMUM of 10mins
Check the appliance is free from all obstructions and remove safely
Switch ON the appliance at the mains supply socket
Operate the appliance as shown above
If the appliance fails to operate, repeat the above procedure ENSURING the appliance is
disconnected from the mains supply at the wall socket.
If after repeating this procedure the appliance fails to operate CHECK the fuse within the wall
socket / plug. If after carrying out both of the above procedures the appliance still fails to
operate, then call a competent Service Engineer.
CAUTION : In order to avoid a hazard due to inadvertent resetting of the thermal cut-out,
this appliance must not be supplied through an external switching device, such as a
timer, or connected to a circuit that is regularly switched on and off by the utility.
Care and Cleaning
Always disconnect the appliance from mains supply and allow to cool before any
cleaning operation begins.
Chrome parts can be cleaned using a clean, damp cloth.
The Side / end panels and any metal painted parts may be cleaned using a clean, damp cloth.
Never use any abrasive cleaners and chemical agents as damage may occur to the paint
finish.
Maintenance
WARNING
BEFORE CARRYING OUT ANY MAINTENANCE, ENSURE THAT THE APPLIANCE IS
DISCONNECTED FROM THE MAINS ELECTRICAL SUPPLY. IF IN DOUBT SEEK THE
ASSISTANCE OF A QUALIFIED ELECTRICIAN
It is advisable to use genuine Flavel replacement parts available from your supplier or
direct from Flavel. (Contact details on the rear of this booklet)
To Next Page
Loading...
