Flebi Swan - Display Errors and Troubleshooting

Electrical operation
Display - errors
10
Código de error Descripción Acción recomendada
"04"
Speed throttle does not return to position
zero (remains in the high position
Check if the throttle turned again
"05"
Throttle failure Check throttle
"07"
Overvoltage protection Check battery voltage
"08"
Motor hall signal wire failure Check engine
"09"
Motor phase cable failure Check engine
"11"
Engine temperature sensor failure Check controller
"12"
Current sensor failure Check controller
"13"
Battery temperature failure Check battery
"14"
The controller temperature is too high and reach
protection point
Check engine
"21"
Speed sensor failure Check the installation position of the sensor
speed
"22"
BMS communication failure – replace battery BMS communication failure Replace battery
"30"
Communication failure Check connector to controller
tutorial video: https://youtu.be/4Om40zPttDU