FLUSHING AND CLEANING
IMPORTANT: When cleaning./flushing the Kombi Classic line marker, ensure
that water courses are not contaminated with paint. If in doubt, check with the local
authority.
Quick flush (daily)
This can be used before breaks in operation or at the end of a line marking day.
1. Ensure that the water tank has sufficient water for the cleaning operation.
2. Position the machine where the contents of the pipework can be flushed and
cleaned.
3. With the paint/water tap in the ‘water’ position (Fig 17), turn on the pump. Allow
the water to spray through the nozzle, when clear water is observed turn off
the pump.
.
(Fig 17)
Maintenance
11
To Next Page
Loading...