ASSEMBLING YOUR KOMBI CLASSIC MARKER
PREPARING FOR USE
1. Carefully remove the machine and accessories from packaging.
2. Insert handlebar section; adjust to suit user’s height and tighten us-
ing thumb screws.
3. Bar ends can be adjusted to suit hand position using the supplied
5mm allen key.
4. Connect switch using the coiled power cable. (Fig 1)
5. Position machine near a 230/240V AC power supply, connect
charger to charge socket and switch on. (Fig 2)
CAUTION. Only use the supplied charger. Use of other equipment
may cause fire or damage the battery. Maintain battery charge at all
times, charge once a month if stored for long periods without use.
(Fig 2)
6. When charging, the LED on the charger illuminates red. When the
battery is fully charged, the LED illuminates green.
Assembly
2
To Next Page
Loading...