LIVING
WITH
YOUR
MOTOR
HOME
LEVELING SYSTEM (If Equipped)
Controls for the leveling system are located in the
dtiver's compmtment. A detailed operating and
maintenance guide is included
in
your Owner's
Information Package. Read
all
instructions for
this system carefully before operating the system.
A WARNING
The
leveling system is designed
as
a leveling system
only.
Do
not use the system as a jack or with a jack.
Do
not
attempt to raise the tires off the ground. The
system
should be used
to
raise the recreational vehi-
cle
to
the lowest level position possible.
For operation
of
the leveling system the follow-
ing is required:
• Park the
RV
on
level ground
• Ignition on, engine running
• Transmission
in
park
• Parking brake set to the engaged position
• Battery Voltage must be 13.0 Vdc or
greater
POWER ENTRY STEP
(If
Equipped)
The power entry step is controlled by a magnetic
entry door position switch, the engine ignition
switch and by an override switch located near
the
entty door. Power for the entry step is sup-
plied
by the chassis battery (or batteties). The
battery system must
be
connected (battery dis-
connect in the
"ON"
position) for the entty step
to
operate.
The entry step will typically extend and retract
with the opening and closing of the entry door
as
controlled by the entty door position switch
(function is automatic). Activating the
overtide
switch will move the entry step to the extended
position, and it will stay there regardless
of
whether the door is open or closed. Regardless
of
the
override switch position, activation
of
the
ignition key with the entry door closed will
retract the entry step. This helps to prevent inad-
vertently driving
off
with the entty step
extended. The switches operate the entty step
according to the following table.
A WARNING
Always look and be sure the step is extended before
entering or exiting the motor home.
A WARNING
If door is quickly opened and closed without allowing
the step
to
fully extend and lock
in
the "OUT" position,
the step will
immediately retract and lock in the "UP"
position.
Refer to the power step Owner's Manual in your
Owner's Information Package for details
on
maintenance and lubrication.
Ignition
Overdrive
Step
Switch
Switch Position!
Position Position
Action
OFF
OFF
Step extends and retracts
with the opening and closing
of
the door.
OFF
ON
Step stays in the extended
position regardless
of
door
open or closed position.
ON
ON/OFF
Step retracts when the door
is closed.
ENTRY AND SCREEN DOORS
The main ently door uses a latching system sim-
ilar
to
that used in automobiles.
It
has a second-
my latch as well
as
a primary latch. When clos-
ing the door, be sure to close it firmly to engage
the primary latch. This will ensure that the door
is
fully closed.
When
traveling,
always
lock
the
deadbolt.
The screen door may be separated from the main
entty door by depressing the catch
or
releasing the
magnet.
06-1
To Next Page
Loading...
