10
PULL·OUT LOUNGE
INTERIOR
AND
FURNISHINGS
PULL·OUT LOUNGE BEDS
To convert a pull·out
or
lounge seat into a bed, proceed
as
follows:
1.
Release pin
under
cushion.
2.
Pullout
the
support
tray by grasping
the
trim below
the
outside
of
the
cushion, pulling it
outward,
like
a drawer.
3.
Unsnap
the
cushion backs where
they
are
attached
to
the
rear panel. The cushions may have hidden
. fasteners which require a simple pulling
action
of
the tab
to
release.
4.
Slide
the
lower cushions
out,
unfold
the
back cushions
. and lay
them
flat
to
complete
the
bed.
SPRING-BALANCED BUNK BEDS
Spring·balanced
overhead
bunks
(optional) are located at
the
ceiling in
the
front.
Place
both
hands
on
the
center
rim and
pull firmly down and forward against counter-tensioned
springs.
Be
sure
that
fastener straps are
properly
snapped
when
traveling. Swing sun'visors
UP
and
out
of
the
way
before moving
the
front
bunks
down.
When raising
the
bunk
be sure
that
no loose items which may strike
the
ceiling,
are on
top
of
the
bunk.
The
overhead bunk
should
not
be
used as a storage area.
PEDESTAL SEATS
Pedestal seats may have
two
types
of
position controls. The
seat can be moved forward
or
back by releasing
the
catch
under
the
front
of
the
seat.
The
seat may swivel
in
either
direction.'
Be
certain
that
seat controls and locks are secure
prior
to
driving
the
vehicle and never adjust
the
seat position
while
in
motion.
SWING-DOWN DINETTE TABLE
To convert a
swing· down
dinette
table
into
a bed, proceed as
follows:
1.
Reach
under
table
and
fold leg back by releasing
leg
latch.
2. Raise
front
portion
of
table several inches
to
dis·
engage inserts from wall plates.
3. Lower
table
top
into
position
to
complete
base for bed.
4.
Slide seat
and
back cushion
into
place over bed area.
To Next Page
Loading...
Need help?
General
