Flepcher FLP-MT1201 User Manual

MT Series
Professional Power Amplifier Professional Loudspeaker Loudspeaker Cabinet
• Thermal cut-o and circuit breaker to protect amplifiers against over-current
• Specially designed filter to minimize low frequencies which are harmful to speakers
• Low power consumption
• Robust design and can withstand the extreme condition touring
• Patented outlook design and CE certified
The MT1201 power amplifier is designed to maximize reliability. The ability to response to a wide frequency make
it suitable for various scenarios. Additionally, it has low THD level and high S/N ration makes the MT1201 versatile
in professional sound industry.
With thermal cut-o and circuit breaker, the MT1201 is relied upon during critical situation for its endurance and
long-lasting performance. It is also outfitted with a limiter to protect and ensure the sound reproduction system stay
at an acceptable level at all times. With an emphasis on power-saving function, this unit only consumes 0.1A under
a no-load condition. The MT1201 performs best when installed in entertainment outlet, stadium, cinema and other large
places of large gathering.
FLP-MT1201
Power Output Level
RMS @ 8 Ohm Stereo
RMS @ 4 Ohm Stereo
RMS @ 8 Ohm Bridge
RMS @ 4 Ohm Bridge
Frequency Response
S/N Ratio
Slew Rate
Phase Response
Damping Factor (8Ohm, 1f-1kHz)
Line Input
Input Connectors
Dimension (W X D X H)
Weight
1kHz, THD + N = 0.1%
1200 + 1200W
1650 + 1650W
3300W
3800W
20Hz – 20kHz ± 1dB
95dB
≥ 25V/µs
± 10°
650
240V, 50Hz
Female XLR + Male XLR
482 X 483 X 132
41 kg
Specifications
Features
56

Flepcher FLP-MT1201 Specifications

General

Brand	Flepcher
Model	FLP-MT1201
Category	Amplifier
Language	English

Summary

Product Overview and Specifications

Specifications

Technical specifications for the MT1201 power amplifier, covering output, frequency, and connections.

Important Safety Precautions

General Safety Guidelines

Covers handling, power cords, grounding, voltage, and general operational safety.

Operational Environment Precautions

Service and Access Warnings

Front Panel Controls and Indicators

Front Panel Component Identification

Front Panel LEDs and Power Switch

Describes the function of Protect, Limiter, Power, Signal LEDs, and the Power Switch/Circuit Breaker.

Rear Panel Connections and Features

Rear Panel Input Connectors and Mode Switch

Rear Panel Filter, Outputs, and Grounding

Amplifier Operation and Cooling

Power and Circuit Requirements

Cooling System and Airflow

Explanation of the forced-air cooling system and maintaining airflow for optimal performance.

Connecting Audio and Speakers

Mode Selection and Operation Modes

Mode Selection Switch Function

Explains how to configure the amplifier for Stereo, Parallel, or Bridged Mono operation.

Bridged Mono Mode Safety Considerations

Details on Bridged Mono operation, including load impedance and safety warnings.

Amplifier Protection Features

Clip Limiting and Gain Modulation

Explains Active Clip Limiting (ACL) and Instantaneous Gain Modulation (IGM).

Thermal, Fault, and Subsonic Protection

Details Thermal Protection, Short Circuit, DC Voltage Protection, and Subsonic Frequencies protection.

Speaker Protection and Cabling

Preventing Speaker Damage

How to prevent speaker damage from power, clipping, low frequencies, and DC voltage.

Recommended Speaker Cable Selection

Maintenance, Responsibility, and Service

Routine Maintenance and User Responsibilities

Service and Repair Procedures

Appendix A: Detailed Specifications