Flex KEP 91017 - Computer System and Software Requirements; 3 Connecting the USB-Pmbus Adapter

2.1 Computer system and software requirements
System requirements:
• Pentium 1GHz or better processor
• At least 512 MB of RAM
• 10 MB of available hard-disk space
• USB 1.0 port or higher
Supported operating system:
• Windows XP Pro SP2 and later 32-bit Windows version
The following software environment is required:
• Windows Installer 3.1 or later
3 Connecting the USB-PMBus adapter
In the figure below it is shown how to connect the USB-PMbus adapter to, for
example, Flex’s POL design board (ROA 128 3836 R2A). The 10-pin ribbon cable
is connected to the board. The USB shall be connected to one USB port of your
PC.
KEP 91017
USB-PMBus Adapter
28701- KEP 91017
August 2018
© Flex
User Guide
7
KEP 91017
USB-PMBus Adapter
28701- KEP 91017 Rev. A
August 2018
© Flex
User Guide
7