Flex L 15-10 150 User Manual

Instruction manual L 15-10 150 / L 21-8 180 / L 26-6 230
12
4. To switch off, briefly press and release
the switch.
Adjusting the quick-release guard
WARNING
Before carrying out any work on the angle
grinder, always pull out the mains plug.
When using the angle grinder for roughing
or cutting, never work without the guard.
A special cutting guard must be used for
cut-off grinding.
See manufacturer’s accessories catalogue
for the appropriate cutting guard.
CAUTION
Risk of injury! Wear protective gloves.
1. Loosen the clamping lever (1.).
2. Adjust the guard (2.).
3. Retighten the clamping lever (3.).
Attaching/changing the grinding
wheel
WARNING
Before carrying out any work on the angle
grinder, always disconnect the tool from the
power supply.
1. Press and hold down the spindle lock (1.).
2. Using the pin wrench, loosen the clamping
nut on the spindle in a counter-clockwise
direction and remove the clamping nut (2.).
3. Insert the grinding wheel in the correct
position.
4. Screw the clamping nut onto the spindle.
– Grinding wheel ≤
1
/
4
" thick:
Clamping nut collar facing up,
towards shaft end.
– Grinding wheel >
1
/
4
" thick:
Clamping nut collar facing down,
towards gearbox.
5. Press and hold down the spindle lock.
466.387_L15-10 150_L21-8 180_L26-6 230.book Seite 12 Montag, 19. März 2018 2:35 14

Flex L 15-10 150 Specifications

General

Brand	Flex
Model	L 15-10 150
Category	Grinder
Language	English