Need help?Do you have a question about the Flex DGE 25 18.0-EC and is the answer not in the manual?
General| Voltage | 18 V |
|---|---|
| Disc diameter | 125 mm |
| Tool Fixture | M14 |
| Spindle thread | M14 |
| No-load speed | 8500 rpm |
| Battery Capacity | 5.0 Ah |
| Idle Speed | 8500 rpm |
Explains symbols in the manual, on the tool, and provides essential safety warnings.
Details the tool's purpose and offers general safety instructions for operation.
Covers safe practices for installing and using accessories, and personal protective equipment.
Provides specific guidance and warnings to prevent hazardous kickback situations.
Explains kickback causes and how to support workpieces to minimize risks.
Details specific safety measures for grinding and abrasive cutting-off tasks.
Safety guidelines specific to using wire brushes, including bristle discharge.
Presents noise and vibration emission levels and related safety advice.
Pre-operation checks, unpacking, and initial battery charging instructions.
Step-by-step guide on how to insert and replace the battery pack.
Instructions for fitting accessories and changing the clamping nut safely.
Details on attaching the filter cover and operating the power switch.
Guidance on adjusting the tool's speed settings before operation.
Procedures for regular cleaning and maintenance of the power tool.
Information on obtaining spare parts and additional accessories for the tool.
Guidelines for environmentally friendly disposal of the tool and batteries.
EU compliance statement for the product, listing relevant directives and standards.
UK compliance statement for the product, listing relevant regulations and standards.
Manufacturer's disclaimer regarding damages from improper use or third-party products.
To Next Page
