Flex DGE 25 18.0-EC - Operating Instructions; Before Switching On; Battery Insertion and Replacement

19
DGE 25 18.0-EC
Technical data
Tool DGE 25 18.0-EC
Type straight grinder
Rated voltage Vdc 18
No-load speed r.p.m 10000-25000
Collet
mm
mm
mm
6
6.35 (1/4") ( sold
seperately)
8 (Sold separately)
Carbid burrs (max.
diameter)
mm 16
Mounted points
(max. diameter)
mm 32
Mounted ap
wheels
(max. diameter)
mm 30
Cutting discs (max.
diameter)
mm 50
Abrasive grinding
body diameter
max.
mm 32
Weight according
to”EPTA
Procedure
01/2003”
(without battery)
kg 1.5
Battery
AP
2.5
AP5.0
Weight of battery
- 2.5Ah
- 5.0Ah
kg
kg
0.4
0.7
Charging time
(depending on
state of charge)
- AP 2.5
- AP 5.0
min
min
0-40
0-45
Working
Temperature
-10
－
40℃
Storage
Temperature
-40
－
70℃
Charging
Temperature
4~40°C
Overview (see gure A)
The numbering of the product features refers
to the illustration of the machine on the
graphics page.
1 Collet (SW17)
2 Clamping nut
3 Spindle button
4 Handle
Insulated gripping surface
5 Speed-selection button
6 On/o switch
7 Filter cover
8 Open-ended spanner
Operating instructions
WARNING!
Remove the battery before carrying out any
work on the power tool.
Before switching on the power
tool
Unpack the cordless straight grinder and
check that here are no missing or damaged
parts.
N
OTE
The batteries are not fully charged on
delivery. Prior to initial operation, charge the
batteries fully. Refer to the charger operating
manual.
Inserting/replacing the battery
(see gure B & C)
WARNING!
Before inserting the battery, make sure that
the product is switched o.
󰀲
Press the charged battery into the power
tool until it clicks into place (see gure B).