2.4 In explosive or inflammable atmosphere
CAUTION
This machine is not suitable for use in explo-
sive or inflammable atmospheres or where
such atmospheres are likely to be produced by the
presence of volatile liquid or inflammable gas or va-
pour.
3 Control / Operation
CAUTION
Damage due to unsuitable mains voltage.
The appliance can be damaged as a result of
being connected to an unsuitable mains voltage.
1. Ensure that the voltage shown on the rating plate
corresponds to the voltage of the local mains
power supply.
3.1 Starting and operating of the machine
1. Check that the electrical switch is switched off
(in position 0).
2. Check that suitable filters are installed in the
machine.
3. Connect the suction hose into the suction inlet at
the machine by pushing the hose forward until it
fits firmly in place at the inlet.
4. Connect the tubes with the hose handle, twist
the tubes in order to ensure that they are prop-
erly fitted.
5. Attach suitable nozzle to the tube. Choose noz-
zle depending on what type of material that is to
be picked-up. If used for dust extraction in con-
nection with dust producing tool then connect
end of suction hose with appropriate adapter.
6. Check that hose diameter setting corraspondes
to actual hose diameter.
7. Connect the plug into a proper electrical outlet.
8. Put the electrical switch into position I in order to
start the motor.
Turn I:
Activate the machine
Turn
:
Stop the machine. Permanent power
on socket
Turn
:
Activate Auto-On/Off operation
Turn I+
Off: Activate the machine
with deactivated automatic filter
cleaning function
Turn
+ Off: Activate Auto-
On/Off operation with deactivated
automatic filter cleaning function
Speed control operation on separate
turning knob
The hose diameter and the setting for suction hose
diameter must be the same.
ø
2
1
ø
2
7
ø
3
2
ø
3
6
ø
3
8
ø21 ø21
ø27 ø27
ø32 ø32
ø36 ø36
ø38 ø38
3.2 Auto-On/Off socket outlet for power tools
CAUTION
Appliance socket.
The appliance socket is designed for electrical
auxiliary equipment; see technical data for refer-
ence.
1. Prior to plugging in an appliance, always switch
off the machine and the appliance that is to be
connected.
2. Read the operating instructions to the appliance
to be connected and observe the safety notes
contained in these.
An appliance socket with earthing contact is inte-
grated in the machine. An external power tool can
be connected there. The socket features permanent
power on, when the electrical switch is in position
, i.e. the machine can be used as an extension
cord.
In position
the machine can be switched on
and off by the power tool connected. Dirt is picked
up from the source of dust immediately. To comply
with regulations, only approved dust producing tools
should be connected.
To Next Page
Loading...
