Flexco Roller Lacer User Manual

Installing Clipper
®
Fasteners with
the Roller Lacer
®
and Microlacer
®
1. Square belt end off centerline. 2. Select the proper size hook for your
application.
3. If belt has an impression cover, skive back
1" (25mm) from the belt end.
Prepare Lacer for Use:
Belt Preparation:
Face Strip Installation
2. Position lacer head to the end of the tool.
Turn knob clockwise to open rollers.
B
C
3.Inserthooksintotherstactiveslotofthe
face strip. Secure with lacer pin.
4. If using hooks as shown in A or B, remove
carding paper at this time. If using hooks
as shown in C, remove carding paper after
installing hooks.
1. Loosen hex screw to allow Face Strip
Retaining Latch to rotate out of the way.
Insert Face Strip, reposition Latch and
tighten screw.
HEX SCREW
LATCH
CONTINUOUS
LACING SLOTS
ADJUSTING KNOB
FIRST ACTIVE SLOT
Lacer Operation:
2. Lock belt clamp.
1. Guide belt through clamp; insert belt end
intohookpointsandushagainsttheentire
width of the face strip.
ROLLER LACER
1
1
2
2
3
3
4
4
A A
B B
C C
D D
TITLE
SIZE
DWG NO
REV
SCALE
SHEET OF
DRAWN
CHECKED
QA
MFG
APPROVED
1
1
C
TVandeVegte
2/20/2004
MICROLACER
For Roller Lacer Serial Nos. 60000+; Microlacer Serial Nos. 40000+
A
Belt clamp
knob

Flexco Roller Lacer Specifications

General

Brand	Flexco
Model	Roller Lacer
Category	Tools
Language	English

Summary

Belt Preparation

Square Belt End

Ensure the belt end is squared off the centerline for proper installation.

Select Hook Size

Choose the correct size of hook suitable for your specific application requirements.

Skive Belt for Cover

If the belt has an impression cover, skive back 1 inch (25mm) from the belt end.

Prepare Lacer for Face Strip Installation

Install Face Strip

Loosen hex screw, rotate latch, insert face strip, reposition latch, and tighten screw.

Position Lacer Head

Insert Hooks into Face Strip

Lacer Operation

Guide Belt and Insert

Lock Belt Clamp

Position Rollers Over Hooks

Adjust Rollers to Touch Hooks

Advance Lacer and Adjust

Move Lacer Head Across Belt

Embed Hooks into Belt

Adjust knob and return head repeatedly until hooks are embedded 1/3 to 1/2 into belt.

Remove Lacer Pin and Belt

Continuous Lacing

Initial Section Lacing

Prepare for Next Section

Position Laced Section

Lace Subsequent Sections

Continue lacing subsequent sections using steps 3-8 of the Lacer Operation instructions.