Need help?Do you have a question about the Flexco Alligator Ready Set RSC187 and is the answer not in the manual?
Explains the critical need for a square cut for belt tracking and splice life.
Details the importance of skiving belt cover for proper fastener penetration.
Details the RSC187 tool for aligning and driving staples.
Explains the air-operated power driver for quick and effortless staple installation.
Checks for correct staple seating, belt puckering, and flush alignment.
Ensures fastener plates are firmly compressed without gaps.
Addresses issues like incomplete staple setting, incorrect fastener size, or improper skiving.
Covers using the wrong hammer type or force, and worn anvils.
Checks for lacing flush with belt surface and slight penetration on opposite side.
Addresses issues with teeth not fully penetrating or clinching over.
Highlights high strength, superior abrasion resistance, and portable installation.
Checks for fully clinched fasteners and proper belt puckering at the top plate edge.
Verifies rivets are fully set on the bottom and loop area is oval.
To Next Page
General
