6
Alligator
®
Staple
Installation Accessories
ALLIGATOR
®
STAPLE
Staple Setting Plate (ST-28)
Final set of the staples and proper compression of the
fastener plate are necessary for long splice life. The heat-
treated steel setting plate provides the required hardened
surface to achieve a properly installed splice. The ST-28
also features countersunk bolt holes for mounting onto a
work surface.
Alligator
®
Hinge Pin Cutter (APC-1)
Cuts bulk hinge pin cable quickly and easily. Provides a
clean cut with no frayed ends.
Hinge Pin Retaining Washers
Retaining washers prevent migration of nylon-covered cable
hinge pins. Check hinge pins frequently during the rst few
hours of operation to determine whether migration is a problem
in your application; use retaining washers if necessary.
Hinge Pin Bender (PB1)
For use with steel spring wire pin. Bends hinge pin end to
prevent pin migration.
Rough-Top Belt Skiver (RTBS)
Durable, hand-operated tool for quick and clean removal of
rough top from light- and medium-duty conveyor belting.
Belt Nippers (BN-1)
A simple, hand-held tool used to notch/chamfer belt edges
and to remove individual fastener plates from belt.
To Next Page
Loading...
