To Next PageTo Next Page
Need help?Do you have a question about the FlexRadio Systems FLEX-6300 and is the answer not in the manual?
General| Type | Software Defined Radio (SDR) |
|---|---|
| Receiver Type | Direct Sampling |
| ADC Resolution | 16-bit |
| Number of Receivers | 2 |
| Software | SmartSDR |
| Output Power | 100W |
| Display Type | None (requires external computer) |
| Antenna Connectors | 2 x SO-239 |
| Transmitter Modes | SSB, CW, AM, FM, Digital |
| Connectivity | Ethernet |
| Operating Temperature | 0 to 50 °C |
| Frequency Range | 30 kHz – 54 MHz |
| Transmitter Frequency Range | 1.8-54 MHz |
| Power Supply | External 13.8V DC (not included) |
Provides general specifications for FLEX-6300, FLEX-6500, and FLEX-6700/R models.
Details transmitter specifications including architecture, power, and frequency response.
Details receiver specifications including architecture, sensitivity, and spectral displays.
Details the pinout and supported microphone types for the front panel mic connector.
Information on the stereo headphone jack, connector type, and impedance.
Description of the CW key/paddle jack and connection for paddles or straight keys.
Explains the soft power control functions and reset procedures for the radio.
Details DC power input, fused protection, USB ports, and powered speaker connections.
Covers the accessory connector pins, clock input, and I2C/PTT signals.
Details TX relay outputs, antenna ports, reference output, Ethernet, and audio inputs.
Details connecting to a PC via Ethernet and installing the SmartSDR software.
