Need help?Do you have a question about the FlexRadio Systems SDR-1000 and is the answer not in the manual?
General| Sample Rate | 48 kHz |
|---|---|
| ADC Resolution | 16 bits |
| Input Impedance | 50 ohms |
| Power Supply | 12 V DC |
| IF Frequency | 9 MHz |
| Receiver Type | Direct Conversion |
| DAC Resolution | 16 bits |
| Type | Software Defined Radio |
| Modulation Modes | AM, FM, SSB, CW |
| Interface | Ethernet |
Introduction to the SDR-1000 software defined transceiver and its capabilities.
Detailed technical data for receiver, transmitter, controls, and physical dimensions.
Details the receiver preamplifier, low pass filters, and other standard hardware.
Information on optional hardware like transverters, power amplifiers, ATU, and clock reference.
Details the 15-pin D-connector for external control, PTT, and other signals.
Explains pinouts for microphone and keyer inputs, including variations and keyer input details.
Step-by-step guide for connecting power, PC interface, and sound card.
Recommendations for sound cards and initial setup considerations for optimal performance.
Covers installing the PowerSDR software, drivers, and the setup wizard process.
Details frequency, level, and image null calibration for accurate operation.
Explains VFO A/B, tuning controls, and the multimeter for monitoring signals.
Covers changing modes, adjusting filters, and configuring display types like Spectrum and Panadapter.
Sets up hardware, options, and calibration routines, including LPT address and sound card settings.
Configures sound card, VAC, noise reduction, blankers, and AGC/ALC settings.
Tailors transmit signal characteristics and customizes the software's visual appearance.
Covers power-up/down procedures and various tuning techniques like mouse wheel and keyboard.
Guides users through setting up and operating in voice, CW, and digital modes.
Explains how to use the Antenna Tuning Unit and addresses common ATU errors.
Provides solutions for common problems like no audio, no power, and frequency errors.
Addresses issues with signal quality, image nulling, USB adapter errors, and ATU communication.
To Next Page
