FlexRadio Systems SDR-1000 User Manual

S E T U P F O R M C H A P T E R 8
Warning: Using a PLL Multiplier/external signal that equates to a clock value
greater than 200MHz can cause heat damage to the DDS chip.
 IF (Hz): Displays the Intermediate Frequency used in the software to avoid low frequency noise.
This is currently locked to 11.025kHz.
Options Sub-Tab
Figure 57: Setup Form - General Tab, Options Sub-Tab
[The rest of this page has been left blank intentionally]
70 FlexRadio Systems

FlexRadio Systems SDR-1000 Specifications

General

Brand	FlexRadio Systems
Model	SDR-1000
Category	Radio
Language	English