S E T U P F O R M C H A P T E R 8
Transmit Tab
Figure 95: Setup Form Transmit Tab
The transmit Tab has controls that allow the user to tailor the transmit signal characteristics using features
like compression and filtering.
DC Block: Attempts to block any DC noise from entering the filter. This is used mainly with lower
quality sound cards or on systems where there are grounding issues.
Tune Power: Sets the power in Watts to be used whenever the TUN (Tune) function is used on the
front console (sets the Drive control). Changes made to the Drive level while TUN is active will be
reflected in this control.
[The rest of this page has been left blank intentionally]
97 FlexRadio Systems
To Next Page
Loading...
