To Next PageTo Next Page
Need help?Do you have a question about the FlexRadio Systems FLEX-6600 and is the answer not in the manual?
General| Type | Software Defined Radio (SDR) |
|---|---|
| Receiver Type | Direct Sampling |
| ADC Resolution | 16-bit |
| Modes | SSB, CW, AM, FM, Digital |
| Output Power | 100 W |
| Display Type | External |
| Connectivity | Ethernet |
| Power Supply | 100-240V AC, 50-60Hz (internal power supply) |
| Number of Receivers | 4 independent receivers |
Important operational notices, regulations, and safety warnings for radio use.
Critical safety precautions for operating the radio, including electrical and physical hazards.
Detailed transmitter specifications, including output power, modulation, and emissions.
Detailed receiver specifications, including architecture, dynamic range, and sensitivity.
Details on connecting the DC power supply to the radio.
Description of the SO-239 antenna connectors and their use.
Description of the high-density HD-15 accessory connector and its functions.
Network connection port for the radio, supporting 100Mbps and 1Gbps Ethernet.
BNC connector for transverter receiver input and exciter output.
Description of the 1/8-inch stereo microphone jack and its pseudo-balanced input.
BNC connector for transverter receiver input and exciter output.
Thumbscrew for attaching an earth ground to the radio's chassis for safety.
Safety considerations for station setup, including ESD and lightning protection.
Guidelines for optimal radio placement to ensure reliability and proper ventilation.
Information on installing the SmartSDR operating software for the radio.
Guidance on selecting appropriate antennas for the FLEX-6400/FLEX-6600 transceiver.
Introduction to the optional GPSDO module for precise frequency control.
Procedure for calibrating radio frequency using automated routines and standards.
