Flexwatch FW1173 - Page 7

FW1173 User’s Manual
M4064-00 7 Seyeon Tech Co., Ltd
Frame rate
(each channel)
Motion JPEG: Up to 30/25
fps @4CIF (Secondary
Stream at QCIF)
H.264: Up to 30/25 fps
@4CIF (Primary Stream at
QCIF)
Motion JPEG: Up to 30 fps
@ 1280H x 720V (Other
Stream at QCIF)
H.264: Up to 30 fps @
1280H x 720V (Other
Stream at QCIF)
M
otion JPEG: Up to 30 fps
@ 1920H x 1080V (Other
Stream at QCIF)
H.264: Up to 30 fps @
1920H x 1080V (Other
Stream at QCIF)
Video Streaming
Motion JPEG and H.264 Dual Streaming (Simultaneously)
Controllable frame rate and bandwidth
Image setting
Compression levels: 6 (Motion-JPEG, H.264)
Color: color, black & white
Voice
8 bit PCM (G.711-u-low), Sampling rates 8KHz, Mono Audio
1ch in & 1ch out
LAN interface
10/100BaseT Ethernet auto sensing
IEEE 802.3af Built-in POE (optional)
IEEE 802.11b/g Exterior Dongle wireless (optional)
SD card slot Built-in
Alarm I/O Interface 1 Photo-coupled input and 1 Relay output
Video Output
1 loop through analog
video outputs
- -
Audio Input(MIC)
Input Impedence : 4 KOhm
Pantom Power : 3.3 Volt
Gain : 20 dB
Jack : 3.5mm Mono
Audio Output(SPK)
Output Impedence : 130 Ohm
Output Power : 50 mWatt
Output Voltage : Peek To Peek 1 Volte
Jack : 3.5mm Stereo
Power Over Ethernet Option
Serial Interface
COM Port: RS-232,
COM ports for console, serial input/output device
Max Baudrate: 115,200 bps
Security features Multi user level protection for camera access, Alarm I/O
Advanced Service
Up to 5.6M memory for Pre/Post alarm buffer
E-Mail, FTP, IP notification, Alarm Notification to e-mail
CGI Call by event or schedule
Built-in Motion detections
Accuracy: 12x12=144 blocks
Motion Sensitivity : -100 ~ 100 : 100 is hypersensitive
PTZ & UART Control
Support
PTZ and UART device control through serial interface Up to 35 PTZ protocols from
Pelco “P”& “D” protocol, Vicon V1311RB, Samsung, Honeywell and Etc,.X10 device
control
Others
Transmit External data(EX:POS) transfer with Video
IP notification by e-mail
Management
Configurable by serial, web or telnet
Remote system update via telnet, FTP OR web browser