SDSD
USB HDMI
21
1
1
9
m
m
1
9
m
m
1
9
m
m
1
9
m
m
QUICK START GUIDE
FLIR
Duo
™
PRO R
Please read the user manual for complete product information. If you have questions
please call our Toll-Free Consumer Help Line at 866.667.7732 for assistance.
STEP 1: POWER TO THE CAMERA
The Duo Pro R requires 12W to function correctly. The camera cannot be powered via a computer
USB port or most cell phone chargers. For power via USB-C, FLIR recommends a wall charger
capable of supplying at least 12W.
The Duo Pro R can be powered through the USB-C port or through the 10-pin JST port using the
cables included with the camera.
On initial power-up, LED 2 will ash red for approximately 15 seconds then change to solid Blue;
LED 1 will turn solid green. This indicates that the device is ready for use.
STEP 3: RECORDING VIDEO
Press the Record button to start recording video to the included memory cards. LED 1 will blink
red to indicate active recording, and the camera will beep. Press the Record button again to stop
recording video.
STEP 2: DISPLAY VIDEO
Duo Pro R can display either analog or digital video. To display analog video to a monitor or
television, use the yellow RCA plug on the supplied Bench Cable to connect Duo Pro R to the
monitor’s video input.
For digital video, connect your camera to an HDMI display through the micro-HDMI camera port.
This will automatically disable the analog video output and turn on the HDMI output.
STEP 4: RETRIEVE RECORDINGS
There are two ways to retrieve recorded video & image les from the Duo Pro R:
• Remove the SD cards from the camera and read the les using an SD card
reader (included on some laptops).
• With the camera powered through the 10-pin JST connector, connect the
camera to a computer using the included USB cable. Note that the camera
must be powered through the 10-pin connection, as most computers cannot
supply 12W through USB to sufciently power the Duo Pro R.
LED 1
LED 1
RECORD BUTTON
LED 2
To Next Page
Need help?
General
