EN-US English
How to charge the battery
You must charge the battery inside the
camera for four full hours (or until the
battery indicator displays a green light)
before you use the camera for the first
time.
Charge the battery by connecting the
power supply to the power connector on
the camera. Note: The first time you
3. Push the On/Off button to turn on the
charge a factory-new battery you must
camera. Note: If the camera does not
turn on and then turn off the camera after
start, push the reset button with a
you have connected the power supply to
non-conductive tool. The reset button
the power connector on the camera.
is located beside the battery
connector, inside the battery
compartment. Then push the On/Off
button again.
4. Open the lens cap by pushing the
lens cap lever.
1. Battery indicator
2. Power supply cable
Quick Start Guide
Follow this procedure to start
5. Aim the camera toward your target of
immediately:
interest.
1. Remove the protective film from the
6. Pull the save trigger to save the
LCD.
image.
2. Insert a miniSD™ Memory Card into
7. To move the image to a computer, do
the card slot.
one of the following:
© 2010, FLIR Systems AB. All rights reserved worldwide.
20
Publ. no. T559169, rev. 003
■ JOB NAME: T559169 ■ OUTPUT: Thursday 18 March 2010, (10:18AM) ■ BATCH FORMATTER VERSION: 7.4.25 ■ PAGE: 20 (of 74) ■ PAGINATION: This side=verso ■
To Next Page
Loading...
Need help?
General
