6
USER MANUAL - Rev 1
FLIR
SCOUT
®
III
2.3 CHARGING THE SYSTEM
To assure proper charging, SCOUT III Series monoculars should be
turned OFF throughout the charging cycle. Charging MUST only be
done when the camera temperature is from 0 to 40°C (32 to 104°F), or
battery damage may occur.
The monocular battery should be fully charged prior to use. To charge
the monocular, lift the cover from the USB port, plug in the USB cable
provided with the monocular, and plug other cable end into a USB
power source.
• When charging the charging indicator will be lit orange.
• When fully charged, the charging indicator will light solid green. The
initial charge time is approximately 5 hours.
USB Port
Charging Indicator
2.4 BATTERY
Your Scout III Series monocular is equipped with a sophisticated power
system that uses a rechargeable internal Li-Ion battery.
BATTERY STATUS INDICATOR
While the monocular is ON, a battery status
indicator is always shown in the corner of
the display image. This indicator provides an
estimation of the remaining battery charge.
BATTERY SAFETY INFORMATION
The SCOUT III Series monocular is a sealed unit with sensitive
electronics and contains no user-serviceable parts. Service or repair
is to be performed only by the manufacturer. The monocular must never
be opened or modied by the user. The monocular contains no user
serviceable components. The battery used in this device may present
a risk of re or chemical burn if mistreated. Do not disassemble the
monocular, store above 60°C, or incinerate. The battery is replaceable
only in the factory. Return the product to the manufacturer for
battery replacement.
Full Charge
Half Charge
Plugged In
1.888.610.7664 info@FLIR-Direct.com
FLIR-DIRECT.com
To Next Page
Loading...
Need help?
General