Operation
5
WARNING
To avoid electrical shock, do not use this instrument when working near voltages > 24V
AC/DC. Do not allow the thermocouple to touch live circuitry.
WARNING
To avoid damage and burns, do not make temperature measurements in microwave ovens.
CAUTION
Repeated flexing can break the thermocouple leads. To prolong lead life, avoid sharp
bends, especially near the connector.
Figure 5.3 Supplied Type-K Thermocouple
Figure 5.4 Thermocouple temperature readout (33.7℃, in this example)
1. If necessary, enable the thermocouple mode in the menu system (under
Measurement). The thermocouple is enabled when the ‘TC’ label is shown
on the display.
2. Connect a Type-K thermocouple sub-miniature plug (see Figure 5.3) to
the jack in the top compartment.
3. Touch the thermocouple probe tip to the surface under test or hold it in air.
Read the temperature value on the display next to the ‘TC’ label, see Fig-
ure 5–4.
4. Go to General Settings in the menu system to select °C or °F temperature
units.
#NAS100014; r. AA/59807/59807; en-US
9
To Next Page
Loading...
