4747
Fliteboard AIR
Post ride
Wash the inflatable bladder with warm soapy water and dry before
storage.
The inflatable bladder can remain inflated, or be deflated and stored
on or o the carbon insert to suit your storage preference.
Regular maintenance
The inflatable bladder can be repaired using the supplied repair kit.
15 – 16 PSI is the recommended inflation pressure.
eFoil
Post ride
Disconnect the Flitecell power cables.
Rinse thoroughly with clean fresh water after every use.
Rinse the inside of the mast (through the notch in the rear of the flange)
with fresh water.
Rinse around the mast flange to wash salt away from the board
connection area (if keeping the board and foil attached).
Regular maintenance
Disassemble the eFoil from the board.
Remove the wing, fuselage cover and tail, and clean thoroughly with
fresh soapy water to remove any built-up salt or sand.
Storage
Always store the eFoil in a clean, dry environment.
To Next Page
Loading...