48
Flite Controller
Post ride
Rinse the Flite Controller in fresh water to clean away salt and
debris. Ensure a steady stream of fresh water is applied directly
into the trigger housing. While doing so press and de-press the
trigger numerous times to loosen any sand, grit, debris that may
aect its performance.
Peel out the rubber cover on the underside and clean this with
fresh water. Ensure this area is dry before replacing the cover.
Regular maintenance
Pre and post season, the 3 torque screws on the underside of the
controller can be undone to release the trigger. This will allow you
thoroughly clean and inspect both the trigger, spring and magnet.
Storage
Store in a cool dry place, out of the sun.
To Next Page
Loading...