4949
Flitecell
Post ride
Wipe Flitecell down with a wet cloth (freshwater), and clean Flitecell
contacts and data connector with Contact Cleaner.
Flitecell is water resistant but it should remain dry where possible.
DO NOT submerge or shower.
Avoid placing Flitecell on the sand, which can make its way into the
Flitecell cavity and scratch surfaces.
DO NOT charge the Flitecell immediately after use. The Flitecell
temperature may be too high. Allow 30mins between riding and
charging to allow for cooling.
DO NOT clean the Flitecell or charger with denatured alcohol or other
flammable solvents.
IF THE BOARD HAS LEAKED AND / OR THE FLITECELL HAS BEEN
SUBMERGED IN WATER, INSPECT FOR WATER INGRESS USING THE
SIGHT GLASS LOCATED ON THE SIDE OF THE FLITECELL. STAND THE
FLITECELL UP ON ITS BOTTOM END FOR ONE MINUTE AND THEN PLACE
THE FLITECELL ON ITS SIDE WITH THE SIGHT GLASS FACING DOWN FOR
ONE MINUTE. INSIDE THE SIGHTGLASS IS A COLOUR CHANGING LABEL
WHICH WILL TURN RED IF WATER IS PRESENT. INSPECT THE SIGHT GLASS
AND CONFIRM THAT WATER IS NOT PRESENT BEFORE CHARGING AND
USING A FLITECELL THAT HAS BEEN IMMERSED IN WATER.
IF A FLITECELL HAS BEEN DROPPED OR DAMAGED, CONTACT
FLITEBOARD IMMEDIATELY AND DO NOT USE THE FLITECELL.
Regular maintenance
Examine the charger regularly for damage to the cord, plug, enclosure
or other parts.
Storage
Keep Flitecell stored out of the reach of children and pets.
DO NOT store the Flitecell near heat sources such as a furnace or
heater. DO NOT leave the Flitecell inside of a vehicle on hot days.
The ideal storage temperature is 22°C – 28°C.
Do NOT store the Flitecell whilst charging. Disconnect the charger
when not in use.
DO NOT store the Flitecell fully charged or discharged for a longer
period of time.
For long term storage a charge state of 75% (2 LEDs on) is optimal.
We recommend that you discharge the Flitecell during your final
session of the season and charge back up to the above state.
To Next Page
Loading...