22
Turning on Fliteboard
1 Carefully close the lid. Make certain nothing is caught in the seal.
2 Twist and lock the two lid latches.
3 A few seconds after the Lid is shut in position, you will hear a
‘beep beep beep’ which signifies that the Flitecell and board have
automatically turned on.
4 If Fliteboard is connected correctly the lid should be securely closed,
and a light will be visible on the Receiver located near the front of the
board deck grip.
5 If the receiver light is not active, open the lid and check that the data
and power cables are properly connected.
6 Flitecell will automatically turn o when the lid is opened.
THE SEAL IS A CRITICAL COMPONENT. IF DAMAGED CONTACT YOUR
DEALER FOR A REPLACEMENT PART. NEVER RIDE THE BOARD WITH
A DAMAGED SEAL.
THE FLITECELL AND CABLES ARE WATER RESISTANT; HOWEVER,
ALWAYS KEEP FLITECELL, CABLES AND BOARD CAVITY DRY. WATER,
ESPECIALLY SALT WATER, CAN ACCELERATE AGING AND CORROSION.
IF YOUR BOARD LEAKS, CHECK SEALS, AND CLEAN COMPONENTS
CAREFULLY.
1
4
To Next Page
Loading...