3737
Flite Controller
Post Ride
Rinse the Flite Controller in fresh water to clean away salt and debris
Storage
Store in a cool dry place, out of the sun. .
Flitecell
Post Ride
Wipe Flitecell down with a wet cloth (freshwater), and clean Flitecell
contacts and data connector with contact cleaner.
Flitecell is water resistant but it should remain dry where possible. DO
NOT submerge or shower.
Avoid placing Flitecell on the sand, sand can make its way into the
battery cavity and scratch surfaces.
DO NOT charge the Flitecell immediately after use. The Flitecell
temperature may be too high. Allow 30 mins between riding and
charging to allow for cooling.
DO NOT clean the battery or charger with denatured alcohol or other
flammable solvents.
IF THE BOARD HAS LEAKED AND / OR THE BATTERY HAS BEEN
SUBMERGED IN WATER, INSPECT FOR WATER INGRESS USING THE SIGHT
GLASS LOCATED ON THE SIDE OF THE BATTERY. STAND THE BATTERY
UP ON ITS BOTTOM END FOR ONE MINUTE AND THEN PLACE THE
BATTERY ON ITS SIDE WITH THE SIGHT GLASS FACING DOWN FOR ONE
MINUTE. INSIDE THE SIGHTGLASS IS A COLOUR CHANGING LABEL THAN
WILL TURN RED IF WATER IS PRESENT. INSPECT THE SIGHT GLASS AND
CONFIRM THAT WATER IS NOT PRESENT BEFORE CHARGING AND USING
A BATTERY THAT HAS BEEN IMMERSED IN WATER.
IF A BATTERY HAS BEEN DROPPED OR DAMAGED, CONTACT
FLITEBOARD IMMEDIATELY AND DO NOT USE THE BATTERY.
Regular Maintenance
Examine the charger regularly for damage to the cord, plug, enclosure
or other parts.
Storage
Keep Flitecell stored out of the reach of children and pets.
To Next Page
Loading...