P0: Means Motor Diameter Setting;(set with 11)
P1: Means Undervoltage setting;(set with 530 )
P2: Means Magnetic pole logarithmic setting;(16)
P3: Means Speed signal selection setting; (choose 0)
P4: Means Speed Km/mile selection setting;(0 is km/h ; 1 is mp/h;)
P5: Means 0(no speed) Star or Slide Start Setting;
0 means 0(no speed) Star ; 1 means Slide Start;
P6: Automatic cruise setting;(0 is no Automatic cruise ; 1 is have;)
P7: Soft start and hard start selection settings;
Generally choose 0 (it’s not too fast when start);
With 1 means it’s Strong speed when start.
P8: Speed limited , Motor Working Power % Setting;
100 means 100% power/speed;
30 means 30% power/speed.
P9: Electric Brake strength setting;
0 means no electric brake; 1 mean normal ;
3 means strong electric brake.
When Showed P0, Press Power button, it will Enter to setting Motor
Diameter, Press to add 1, or press to reduce 1; Wait minutes it will end
and go back.
When Showed P1, Press Power button, it will Enter to Undervoltage setting,
If with 315, it means Undervoltage is 31.5V; Press to add 0.5, Press to
Reduce 0.5;
When Showed P2, Press Power button, it will Enter to
Magnetic pole logarithmic setting; Press to add 1, or press to reduce 1;
Fault display
Display will show some fault when scooter have faults;
Showed : Means Electric Brake Faults;
Showed : Means Motor Faults;
Showed : Means accelerator Faults;
Showed : Means Controller Faults.
To Next Page
Loading...