OPERATING PROCEDURES
NOTE: If machine will not prime or drain, remove service panel and locate solenoid valve (labeled #1). Loosen
hose fitting until a small amount of fluid drips out. Tighten and reattempt prime or drain.
MACHINE SETUP:
1. Fill New Fluid Tank with fresh brake fluid.
2. Connect the machine’s battery cables to the vehicle’s battery.
3. When the machine powers up you will notice the light on the front of the machine always stays lit telling
you you’re connected to power.
4. With all hoses on resting ports press the “PRIME” button.
5. Let machine run until you see fluid in the yellow Tygon lines.
6. Press “STOP” button.
7. Close ball-valve on service hose.
8. Hold “REMOVE FLUID” button down until all lights come on.
This will relieve pressure on the red manifold after priming.
DRAIN THE MASTER CYLINDER:
1. Remove ABS yellow Tygon line from holder and attach suction hose.
2. Remove the master cylinder cover and insert suction hose, then press the “REMOVE FLUID” button on
the control panel.
NOTE: Leave a small amount of fluid in the bottom of the reservoir to make sure no air is
introduced into the system.
3. Press the “STOP” button when finished removing fluid.
CONNECT TO THE MASTER CYLINDER:
1. Find and attach correct master cylinder adapter from adapter kit.
2. Attach yellow hose to master cylinder adapter and make sure the ball valve is in the open position.
3. Press the “M/C PRESSURE” button and verify that there are no leaks around the master cylinder cap.
This button will pressurize the brake system so you can safely open the bleeder screws preventing air
from entering the bleeder.
NOTE: Make sure the pressure hose is not putting any torque on the master cylinder adapter,
which may cause leakage.
CONNECT TO THE BLEEDER VALVES:
1. Raise the vehicle.
2. Verify that all bleeder screws can be opened before attaching Tygon lines.
3. Attach Tygon lines to respective bleeder fittings.
4. Open bleeder screws about 1/4 turn until fluid begins to flow into the yellow lines.
NOTE: Make sure the bleeder stays open after you remove the wrench.
BEGIN THE FLUSHING PROCESS:
1. The lights on the board depicting the wheels of the car will flash from one to the next when no sequence
is selected.
13
To Next Page
Loading...