To Next PageTo Next PageWhy my FLORABEST FAT 18 B3 Trimmer won't start?
If your FLORABEST Trimmer won't start, it might be due to a discharged battery. Try recharging the battery. Alternatively, ensure the battery is properly inserted. A defective On/Off switch or motor could also be the cause, requiring repair at a service center.
What to do if my FLORABEST Trimmer has much vibration and loud noise?
If you experience much vibration and loud noise with your FLORABEST Trimmer, the cutting insert might be broken; consider replacing it. Another potential cause is a dirty trimming assembly, so clean it. If these steps don't resolve the issue, the motor might be defective, requiring service center repair.
Why does my FLORABEST Trimmer give a bad trim?
A bad trim with your FLORABEST Trimmer can result from a broken cutting insert, which should be replaced. Also, a dirty trimming assembly can cause this, so ensure it is clean. Finally, check if the battery is fully charged and recharge if necessary.
What to do if my FLORABEST Trimmer has intermittent operation?
If your FLORABEST Trimmer operates intermittently, it could be due to an internal loose contact, which requires sending it to a service center for repair. The On/Off switch might also be defective.
General| Battery Voltage | 18 V |
|---|---|
| Cutting Diameter | 25 cm |
| Telescopic Handle | Yes |
| Power Source | Battery |
| Cutting Width | 25 cm |
