Trouble Shooting
Problem Possible cause Fault correction
Device does not start
Mains voltage not on
Check plug socket, cable, line and
plug, where appropriate, have re-
paired through electrical specialist
On/Off switch (
6)
defective
Repair by Service Centre
Worn carbon brushes
Defective motor
Device runs with inter-
ruptions
Power cable is damaged
Check the cable and have it
changed by the Service Centre if
necessary
Internal loose electrical
connection
Repair by Service Centre
On/Off switch (
6)
defective
Blades become hot
Blades are blunt
Have the blades (
2) sharpened
or replaced (Service Centre)
Blades are notched
Have the blades (
2) checked or
replaced (Service Centre)
Too much friction due to
lack of lubrication
Oil the blades (
2)
Spare Parts
Replacement parts may be ordered directly from our Service Centre (see p.14).
When ordering, always specify the machine type and the part number in the exploded draw-
ing.
Item 18 (Exploded Drawing) ...........Hand protection ....................Product No. 91092221
To Next Page
Loading...
