What to do if my FLORABEST Trimmer won't turn on?
If your FLORABEST Trimmer isn't starting, ensure the battery is properly inserted. Refer to the "Charging" section for instructions on how to correctly insert the battery.
What to do if FLORABEST FRTA 20 A1 makes a bad trim?
A bad trim with your FLORABEST Trimmer can occur if the cutting insert is broken. Replace it according to the 'Cleaning and servicing' section. Another potential cause is a dirty trimming assembly; clean it as described in the 'Cleaning and servicing' section. Also, ensure that the battery is fully charged; if not, recharge it following the instructions in the 'Charging' section.
Why FLORABEST Trimmer has much vibration and loud noise?
Excessive vibration and loud noise in your FLORABEST Trimmer could be caused by a broken cutting insert. Consider replacing the cutting insert as explained in the 'Cleaning and servicing' section. Another possibility is a dirty trimming assembly. Clean the trimming assembly as described in the 'Cleaning and servicing' section. In some cases, the motor itself might be defective, requiring repair at a service center.
What to do if FLORABEST FRTA 20 A1 has intermittent operation?
Intermittent operation of your FLORABEST Trimmer may be due to an internal loose contact, requiring repair at a service center. The On/Off switch could also be defective.
Why is my FLORABEST Trimmer making much vibration and loud noise?
If your FLORABEST Trimmer is producing excessive vibration and loud noise, it could be due to a broken cutting insert. Replace the cutting insert following the instructions in the 'Cleaning and maintenance' section. Another possible cause is a dirty trimming assembly. Clean the trimming assembly as described in the 'Cleaning and maintenance' section.
What to do if FLORABEST Trimmer gives a bad trim?
A poor trim with your FLORABEST Trimmer could be due to a few reasons. Check if the cutting insert is broken and replace it if needed. A dirty trimming assembly can also cause this issue, so clean it thoroughly. Finally, ensure the battery is fully charged.
Why does my FLORABEST FRTA 20 A1 operate intermittently?
If your FLORABEST Trimmer operates intermittently due to an internal loose contact, send it to the Service Centre for repair.
Why is my FLORABEST FRTA 20 A1 Trimmer vibrating so much and making loud noise?
Excessive vibration and noise in your FLORABEST Trimmer can stem from a few issues. A broken cutting insert could be the cause; consider replacing it. The trimming assembly might also be dirty, requiring a thorough cleaning. Also the motor could be defective.
What to do if my FLORABEST Trimmer vibrates a lot and is very noisy?
If your FLORABEST Trimmer is producing excessive vibration and loud noise, the trimming assembly might be dirty. Clean the trimming assembly as described in the "Cleaning and servicing" section.
How to fix a FLORABEST Trimmer that won't start?
If your FLORABEST Trimmer isn't starting, the battery might be discharged. Recharge the battery as explained in the "Charging" section.
Details critical safety measures concerning electrical connections and avoiding shock hazards.
Outlines personal safety precautions, including alertness, PPE, and avoiding unintentional starting.
Provides instructions on the correct use and care of power tools.
Details safe handling and usage practices for battery-powered devices.
To Next Page
General