EasyManua.ls Logo

FLOS KELVIN LED - Page 2

FLOS KELVIN LED
12 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1
2
<IT> ISTRUZIONI DI INSTALLAZIONE ED IMPIEGO
ATTENZIONE!
La sicurezza dell’apparecchio é garantita solo
rispettando queste istruzioni sia in fase di installazione
che di impiego; é pertanto necessario conservarle.
AVVERTENZE:
- All’atto dell’installazione ed ogni volta che si
interviene sull’apparecchio, assicurarsi che sia stata
tolta la tensione di alimentazione.
- L’apparecchio non può essere in alcun modo
modificato o manomesso, ogni modifica ne può
compromettere la sicurezza rendendo lo stesso
pericoloso. FLOS declina ogni responsabilità per i
prodotti modificati.
- Il simbolo
riportato sull’apparecchio indica che il
prodotto deve essere smaltito in modo differenziato
dai rifiuti urbani.
- Lapparecchio è esente dal rischio di emissione
fotobiologica.
- La sorgente luminosa non può essere sostituita
dal cliente. Per informazioni contattare FLOS.
DATI TECNICI
30 LED. 0,29W (8,7W totali).
ISTRUZIONI PER LA PULIZIA DELLAPPARECCHIO
- Per la pulizia dell’apparecchio utilizzare
esclusivamente un panno morbido eventualmente
inumidito con acqua e sapone.
- Attenzione: non utilizzare alcool o solventi.
<EN>
INSTRUCTION FOR CORRECT INSTALLATION AND USE
WARNING!
The safety of this fitting can only be guaranteed
if these instructions are observed, during both
installation and use. Please retain these instructions
safety.
REMARKS:
- When installing and whenever acting on the
appliance, ensure that the power supply has been
switched off.
- The appliance may in no way be modified or
tampered with, any modification may compromise
safety causing the appliance to become dangerous.
FLOS declines all responsibility for products that are
modified.
- The symbol
shown on the device indicates that
the product must be thrown out in a different manner
than with the urban trashes.
- The device carries no risk of photobiological
emissions;
- The light source cannot be replaced by the
customer. Contact FLOS for information.
TECHNICAL DATA
30 LED. 0,29W (8,7W Together).
CLEANING INSTRUCTIONS
- Use only a soft cloth to clean the appliance,
dampened with water and soap or mild cleanser if
needed for resistant dirt.
- Warning: do not use alcohol or other solvents.
21548 ISTR.MONT.KELVIN LED GREEN MODE EUR-USA.indd 2 12/07/12 09.15

Related product manuals