370542 D/GB
21
GB
B. Importance Notice
In general
Prior to start working with this machine read, the operating instructions and safety precautions carefully. All
labels on the machine must always be observed and maintained in a legible condition. Installation, operation,
maintenance and repairs of the machine should be performed only by authorized and qualified personnel. From
the operator is always expected to apply safe working practices and to follow all applicable local safety
regulations and requirements.
The operator is responsible for ensuring that the machine is maintained to provide safe working conditions at all
times and that the as standard installed safety devices are not bypassed or overridden. These safety instructions
are general and do apply to different types of machines and equipment. It is therefore possible that some of the
statements made here are applicable to the respective machine.
Besides the usual safety information applicable to all machine tools and their components the following safety
information are of particular importance. Keep the operating instructions always available to operators and make
sure that the operation and any maintenance of the machine are carried out according to all applicable
instructions. Failure to follow these instructions and/ or unauthorized changes to the machinery and its
components supplied by FLOTT will lead to exclusion of warranty claims. The manufacturer assumes no
responsibility for any damage and/ or personal injury caused by failure to follow these safety rules, or by neglect
of ordinary care, caution in handling, operation, maintenance and any unauthorized and / or improper repair of
the machine.
Transport
ATTENTION! Always check delivery for completeness and damage!
The carrier (forwarder or railway) has to be informed immediately in case of transport damages.
(s. yellow leaflet)
The machine is suitable for the transport by forklift or pallet truck.
The general and local regulations for the transport of machinery do apply.
Noise
1. The noise level of this belt grinder is about 80 db during operation.
2. The noise level of the working environment must be taken into consideration while taking appropriate
provisions for the risk of noise.
Lighting
1. Always provide sufficient light for operation according to the codes or regulation published for local area.
2. If you do not get the information about lighting, a light intensity of 300 Lux is the least value that should be
supplied.
Protection of Multiple Working Area
1. No matter operating in which working area, the other moving area should be covered as far as possible to prevent the risk
due to the contact with it.
To Next Page
Loading...
