13
5.3 For silicone rubber, which can be bought in tubes it’s possible to transfer the material directly
to the syringe. Cut the tip of the dispenser to the diameter that fits the groove around the nozzle of
the syringe (Img. H2.11 - Img. H2.12). Then press the red cap to the bottom of the syringe. Press
out the silicone from the tube (use a silicone gun) directly to the nozzle by keeping the tube and
syringe together (Img. H2.13). This method will prevent from any air presence inside the syringe.
Image H2.11 - Cut away tip of dispenser Image H2.12 - Fit dispenser into syringe
Image H2.13 - Dispenser and syringe
To Next Page
Loading...