11. CONNECTION OF ELECTRICAL INSTALALTION
1. The power connection should be made in accordance with the technical documentation. The device
installation should always be carried out in accordance with applicable local safety standards.
2. The cross-section and type of cable should be selected by the designer. (Always make sure that the
disconnectors and protective switches are properly sized).
3. Make sure that the connection of power supply and controllers to the Slim curtain is made in
accordance with the electrical specifications and the instructions included in the connection diagrams in
the technical documentation.
4. Before connecting the power supply, check that the mains voltage corresponds to the voltage on the
device's type plate.
5. Check the power connection before connecting the air curtain.
6. Starting the device without connecting the grounding wire is not allowed.
7. Protect the power cord against pulling out by clamping the PG16 or PG11 cable gland
8. Tighten all connection cables in the block properly
9. In the event of a hazard due to unintentional reset of the thermal switch, this curtain (SLIM E) should
not be powered by an external connecting device such as a time switch, or connected to a circuit that is
regularly switched off and switched on during use
To Next Page
Loading...
General