Parc Lafayette
6 rue Isaac Newton
25075 Besançon
France
+33 3 81 54 56 00
Contact@flowbird.group
V3 CLESS – User Manual
www.flowbird.group
1- SAFETY INSTRUCTIONS
A- In order to power down your V3 CLESS :
Disconnect the V3 CLESS power supply block from the electric power
supply network
B- Electrical power supply
Only use Flowbird CLESS reader cable
Only use Flowbird antenna cable with it’s Ferrite for EMI protection
The V3 CLESS input voltage should be +12VDC +/- 10%
C- Reader cover Flap
The cover flap located on the side ( see chapter – installation and removal
of Sams) must be in place during normal operation
D- Warning
Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This device must be professionally installed
To Next Page
Loading...