Self-erecting portable greenhouses Take Down Instructions
Page 1
Step 1: Begin first by
removing all of the stakes.
It may be easier for you to
use one stake to remove
another.
Step 2: Be sure your doors and screens are zipped
closed, then place your PlantHouse™ on it's side and
remove the fiber pole from the ceiling.
Step 3: Push on the center
steel band. The two top bands
must be forced to lay
uniformly on top of the two
bottom bands so your
PlantHouse™ will fold into two
panels.
Step 4: Folding one panel on top of the other panel
your PlantHouse™ should be one flat panel. Shown
in Photos 4 & 5.
Step 5: Choosing the top corner, fold your
PlantHouse™ in half. You will feel the tension of the
spring steel. Continue folding under while you bring the
left side up and over. Your PlantHouse™ should
resemble a taco. See photos 6 & 7.
To Next Page
Loading...