Need help?Do you have a question about the Flower House SpringHouse and is the answer not in the manual?
General| Material | Polyethylene |
|---|---|
| Frame Material | Steel |
| Color | Green |
| UV Protection | Yes |
| Ventilation | Screened vents |
| Assembly | Tool-free |
| Door | Zippered door |
Unpack SpringHouse, allow it to spring open, and assemble fiber poles.
Install the top roof pole and sidewall support poles into designated pockets.
Insert L-shaped poles into the center bracket and stake the greenhouse.
Secure the SpringHouse with stakes at 45° angles and install high-wind tie-downs.
Insert capped ends of the X-shaped fiber pole into pockets above doorways.
Insert L-shaped poles into floor pockets and the X-shaped piece, then tie them.
Unzip and roll doorways and screens, securing them open with straps for ventilation.
Remove all high-wind tie-downs and stakes, then detach L-shaped poles.
Tip the SpringHouse over, push the center band to fold it inward, then fold in half.
Continue folding the greenhouse into three rings and pack it into the carry bag.
To Next Page
