Flowtron ACS900 User Manual

Compliance Monitoring; records and displays
actual therapy as well as non-compliant time. Alerts
upon garment removal to facilitate tracking and
documentation of IPC therapy.
Enable/Disable Compliance
Monitoring
1. Congure Compliance Monitoring:
• Make sure no garments are connected to the
pump.
• Press and hold the middle control button to
access the setup screen.
2. Press the left button to cycle through the options:
• ON with Audible alert enabled
• ON with Audible alert disabled
• OFF (Pump run-hour time is displayed instead
of accumulated therapy time)
ON/OFF
3. Press the middle control button to select the
displayed option.
Reset the Compliance Monitoring
(accumulated therapy time)
1. When the pump is in Standby, press and hold
the right control button for 2 seconds. The time
ashes for 2 minutes. Press and hold the middle
control button for 3 seconds to reset the time to
zero.
2. Press the right control button again to conrm. If
the button is not pressed within two minutes, the
timer will NOT be reset and will go back to show
the original data.
Start therapy
1. Apply the garment to the patient.
2. Connect the garment to the pump.
3. Press the middle control button to start therapy.
“Click”
08.FL.01_01EN • 09/2022 • Page 1/2
QUICK REFERENCE GUIDE - USE
Flowtron ACS900
Compliance Monitoring

Flowtron ACS900 Specifications

General

Category	Medical Equipment
Model	ACS900
Portability	Portable
Purpose	DVT prevention
User Interface	Digital Display, Touch Panel
Pressure Settings	Adjustable
Power Source	AC power
Power Supply	AC power

Summary

Compliance Monitoring

Enable/Disable Compliance Monitoring

Configure compliance monitoring settings, including garment connection and setup access.

Reset Accumulated Therapy Time

Reset the accumulated therapy time by pressing specific control buttons on the standby pump.

Start Therapy Session

Apply and connect the garment to the pump, then press the middle button to begin therapy.

Read the Display

Displaying Therapy Time

Accumulated therapy time is shown in the bottom right corner during pump operation.

Indicating Garment Status

Flashing limb graphics on the display signal garment removal from the limb.

Showing Non-Compliance

After 1 hour of non-compliance, the display shows time in flashing hours.

Rectify Warning/Alert

Clearing Compliance Alerts

Refit removed garments to clear compliance monitoring warnings; non-compliance time resets automatically.

Alternative Alert Resolution

Pause and then restart the pump as an alternative method to resolve alerts.