Flowzone TYPHOON 3 - Getting Started: Assembly Part 1; Initial Assembly Steps

TYPHOON 3 OPERATION GUIDE
FZVAAK-3
© WESSOL, LLC 2022
- 10 -
GETTING
STARTED
Setting up your
sprayer
Take off the tank lid (1).
Remove the nuts and
bolts (6), holsters (4, 5)
and nozzles (13, 14, 15)
from the tank strainer (3).
Set aside.
Bring the ComfortStraps™
(11) to the bottom of the
tank. Secure the lower
strap clips to the loops at
the bottom of the tank.
2
3
A B C
Next, slide the adjustable strap through the top tank loop.
Continue by sliding the strap under and over the buckle
tting. Lightly tug to make sure the strap is secure. Repeat on
other side.
1
NOTE: The sprayer may
have residual water in it
when rst opened. This is
due to quality testing every
sprayer undergoes before
leaving our factory.